YOU'LL NEED.....
1) A large mixing bowl
2) Cup Cake Soap moulds (4 on 1 sheet x 2 for these quantities)
3) Kitchen scales
4) A hand sprayer containing clean cold water
5) A small saucepan
6) An electric mixer
7) Paper cup cake cases

INGREDIENTS
300g Bicarbonate of Soda
100g Citric Acid
10ml Fragrance or Essential Oil of your choice
Colour (food/cosmetic/soap liquid colours are fine. Also powders i.e. ultramarines or oxides)
200g White (opaque) melt & pour soap base

HOW TO.....
Measure out the bicarbonate of soda and the citric acid into the mixing bowl, seiving if necessary and thoroughly mix together until you have a consistent texture.

If using liquid food or cosmetic/soap colours, add, in drops, enough colour to make the shade you want, mixing it in quickly to avoid it fizzing up.

If using a powdered colour, simply add, a little at a time, until you have your desired shade.

Measure 10ml of either fragrance or essential oil into mixture. Most essential or fragrance oils will not cause the mixture to fizz, but certain citrus oils may, so if this happens, mix in quickly and thoroughly.

Do not leave the mixture to stand or it will slowly start to set.

Now, a little at a time and working the mixture all the time, spray a little water on it with the hand sprayer. Mix continuously to avoid it fizzing-up in the bowl and ONLY ADD ENOUGH WATER TO HAVE THE MIXTURE START TO HOLD TOGETHER WHEN LIGHTLY SQUEEZED IN YOUR HAND.

Once this point is reached you need to work quickly to compress the mixture into your moulds.

Using our cup cake 4-on-1 mould, this mixture will make approximately 8 cup cake bases. Press the mixture into each mould firmly and leave a raised (slightly domed) top surface.

After 30-40 minutes they should be quite hard. Simply take the bath bomb from the mould and leave it to dry.

Take your cup cake paper cases and put one in each of the now empty moulds, then drop a bath bomb into each paper case, allowing the top of each case to come above the top of each bath bomb.

Next, gently melt your 200g of white soap base in the saucepan over a low-medium heat. Once melted completely, remove from the heat and add any liquid colour you may want to, then, using the electric whisk, whisk briskly until it becomes a light, airy consistency. This is generally achieved by whisking past the stage where it forms large bubbles and as the soap cools slightly it will become a smooth, near-mouse-like consistency. Once there, quickly, before it sets up, spoon your mixture like icing onto each cup cake base, making sure it completely covers the top of each bath bomb and is contained by the paper case. Allow to cool and set.

There! You've made cup-cake novelty bath bombs. Wasn't that easy!

You may have some left-over whisked soap base. If you try and reduce the quantity of soap base to avoid waste, the small amount may not effectively whisk successfully to the consistency you want. Left-over soap can be re-melted and re-used.

HINT... Beginners will usually find Granular Citric Acid easier to use. To improve the look and texture of the bath bomb, use Powdered Citric Acid, although care needs to be taken not to use too much water or they will start to 'grow' before they set hard.

Tip... To make your cup cake novelty bath bomb even more convincing, place the cup cake base in a real cup cake paper case and 'ice' the cup cake in the case.

Tip... Put some cosmetic glitter into a pepper-shaker and shake a fine glittery layer over your 'icing' quickly before it sets.

Tip... Make some tiny melt & pur soap flower or fruit shapes (using embedment/decoration moulds) and place them on the surface befor it sets.

For all your ingredients, visit our on-line catalogue. Everything you need right here..........